20A IGBT PWM DC LED Dimmer motor Speed Control Switch governor

IGBT DC dimmer, 48V DC dimmer for battery charging lighting. PWM DC Dimmer 9v-60v DC motor controller switch that uses PWM to regulate motor speed. Mini LED 20A speed dimming control switch.

PWM DC Motor Speed Control Switch Governor 9V-60V 20A

Dimming of mini PWM of 10A LEDs' speed can be controlled through the switch

Operation Voltage DC 9V 12V 36V 24V, 48V, 60V

This dimmer can be application for constant voltage driver LED lighting, it adopted the most advanced PWM (pulse-width-modulation) digital brightness-adjusting technology that enables you adjust the brightness with the infinite knob. It could be capable of meeting different demands for brightness over different times by using dimming. It also can prolong the lifespan of the light bulb while cutting off the energy consumption. It is ideal for dimming light bulbs with lower power.

The DC Motor Speed Controller with  a Power-On switch, which controls the speed of a DC motor by adjusting Pulse-Width-Modulated (PWM).

Product parameter:

Operating voltage DC 9v ~ 60V

Maximum current: 20A. Most efficient use is at or below 18A.

Control Power: base on voltage 0% - 100%.

The Static Current/Quiescent Present 0.02A(standby)

The PWM dimming can range from 10 percent to 100 percent. Take note that because of the massive Capacitor that controls motors, the PWM range of dimming can vary between 20 percent to 100% in instance of the constant voltage driver LED lights.

PWM frequency 25KHZ

Make sure you are secure even if discover that the connections for both the negative and positive parts of the DC power supply switch

Size: 92*52*36mm. The switch hole is 7MM

Instructions to operate:

1.Before you try to connect the controller , ensure that the controller's power shut off.

2.Please make sure that all connections have been checked before applying power. It may cause harm if you connect your source's voltage to the wrong location.

3.Turn off the engine, and then change your potentiometer.The LED will show the amount of power utilized along with the speed of the motor.

4.You can regulate the speed the speed at which the motor operates with an accelerometer.

Note:

1.Please avoid connecting your AC (for instance: you're at home and have the 220V voltage ),otherwise it could be burned!

2.The terminals of the positive or negative wires in the DC power supply aren't in a position to be reversed.

3.Turn off the source of power prior to making any wire modifications.

4.We suggest that you install an appropriate fuse and an appropriate positive in order to prevent damage from happening.