18W Osram led chip UL listed SCR dimming 2D fluorescent retrofit, 2G11 2d 4-pin led replacement, 2d 2-pin LED replacement. 2d 4-pin led replacement, 2 pin 2 pin led replacement

UL FCC Certificated phase dimming led bulb to replace to Dimmable Osram Philips Fluorescent Lamps. Replace 2D fluorescent tube with LED bulb, Retrofit fluorescent LED, 2D led retrofit , and 2D LED replacements. Warm and cool White Nature white option. 2G11 2d 4-pin led replacement, 2d 2-pin LED replacement. 2d 4-pin led replacement, 2 pin 2 pin led replacement. AC120V Triac dimmable LED bulb 2G11 2G10 LED tube with 36 watt CFL replacement for 2G10, Retrofit fluorescent LED, 2D retrofit led and 2D fluorescent LED replacements.

Dimmer compatibility test 
Test Condition: Vi: AC110-120V 50/60HZ Pi:15W@120V PF>0.9,  flicker less than 10%

compatiable below list dimmer:
Lutrun dimmer:
DVCL-153P
MRF2-6CL
DV-603PG
MSCL-OP153M
S-600P
S-603P
MACL-153M
CTCL-153P
SCL-153P
MSCL-VP153M
DV-600P
SFSQ-F

LEVIN Dimmer:
6672
6674
6631
6633-PLW
6633-P
6161-A
IPL06-10Z

EATON Dimmer:
DAL06P

2G10 LED bulbs that have 4 pins standard base. plugs directly into the fluorescent prong receptacles. It does not require energy-wasting ballasts. It will provide 55 percent Energy Savings, No fluorescent paint or gas contamination of buildings, Green Light Source, Bypass costly ballasts and Wire Direct. How to make use of LED T5 and U-Shape Fluorescent Tube LED Replacing. The best method to utilize LED lights to replace small fluorescent bulbs.

1.) LED Chip: Uses Osram  led chip

2.) Dimension: 160mm x 160mm*16mm

4) Luminous flux: >1500LM, Ra>80

5) Life Time 30k Hrs

6.) Colour Temperatures: Cold White and warm white Nature alternative

7.) Power: 16~18 Watt

8.) The socket: wire conects as 2G10 2.G11

9.) Phase Dimming led bulb is replacing Osram or Phillips phase dimming fluorescent 36W

Simple to set up, take off or bypass your ballast Be sure to check carefully the dimensions of the bulb to make sure that the power and voltage are compatible before ordering. Ballasts should be dismantled or bypassed prior installation of the bulb. If you have an existing ballast attached to the fixture, you should remove it prior to installing your led bulb.Otherwise the bulb may be likely to flicker.